11. Solidworks tutorial: SWEEP

SWEEP

Table Of Contents:
1. AutoCAD vs Solidworks – Which one do I learn?
2. Create a simple 3D object
3. Easy to follow 3D sketching using Solidworks
4. How to draw a coke bottle
5. Solidworks tutorial: sheet metal
6. Solidworks tutorial: Solidworks equation
7. Solidworks tutorial: How to Create a Sphere in Solidworks
8. Solidworks tutorial: Circular pattern
9. Solidworks tutorial: How to mirror parts
10. Solidworks tutorial: Using the LOFT command
11. Solidworks tutorial: SWEEP
12. Solidworks tutorial: Extrude

SWEEP is the one feature in Solidworks that helps sweep a closed profile along a closed or open path. In this session, we are going to use a simple 3D object as an exercise to demonstrate the use of the SWEEP command in Solidworks.
Let’s right dive into it.




Solidworks SWEEP


Step 1

Create a New Part

Step 2

We need to select the desired plane. Click on the Top Plane and select Sketch

Step 3

Make a circle with the origin of the sketch as the origin of the circle and click on Smart Dimension. Enter 50 mm to specify the diameter of the circle.

Step 4

Click on the Top Plane, go to features, select Reference Geometry and select Plane

Step 5

Select the Top Plane to indicate the first Reference and enter 70 mm




Step 6

After creating plane1, draw a circle with 70 mm as diameter.

Step 7

Use the LOFT command to come out with the following image.

Step 8

Now, we are going to create a Path for the Sweep Extrude command. Select the Front Plane,  select Sketch and use the Spline command to draw a Spline as shown on the image below. Thi will serve as a trajectory or path to the SWEEP command.

Step 9

Create another plane but this time, consider the Right Plane as the first reference and the point at the end of the path as the second reference to create a new plane. The path can be open or closed, a set of sketched curves contained in one sketch, a curve, or a set of model edges

Step 10

Create a sketch on the Plane2, use CenterPoint Straight Slot command to create a profile for sweeping and give the same dimensions as marked on the image below. The profile must be closed for a base or boss sweep feature.

Step 11

If you were to create a spring model, a complex hollow pipe, an air conditioning duct, a curved rod, tubes and twisted parts, this command will be almost inescapable.
To put the final touch to our session, click on Sweep Boss/Base and select the profile and the path following the demo below.



Step 12

Create a sketch on the highlighted surface and draw a circle of 60 mm of diameter.

Step 13

Use the Extrude Cut command, give 65 mm and 6 degrees to the depth of the cut and draft the angle accordingly.

Without exaggeration, this command can be placed amongst the 10 most used commands in Solidworks making it a must-know to anyone looking to model using Solidworks.